top of page

Vacuum calibration tank

Flat and Round drippers line

- Max pipe diameter: 50mm

- Standard tools: 16mm

- Made of 316- stainless steel. Tank wall steel 2.5mm thickness.

- The vacuum system works in pouring principle – vacuum only in the upper chamber, keeping good vacuum stability.

- vacuum tank length: 5m, 4.6m Net.

- 3 tempered glass lids

- 2.5'' inch filter with online wash capability

- 4 electronic flow meters to control water flow in calibrator and cold bridge area

- analogic controlled vacuum intensity by PLC

- analogic controlled water pumping intensity by PLC

- a user-friendly touch screen HMI + PLC to control the system

- an electric piston to drive the system FWD/REV

- an ultrasonic sensor to control system position

- automatic drive to a desired position, and the ability to control motion speed

- automatic system retract

- coated rails to prevent corrosion and rust

- X-Y system with micrometers to control adhesion wheel

- easy to remove, 4 screws assembly to easily remove the adhesion wheel for maintenance or replace

- 2 options for calibrator:

1. water cooled, without pouring the water back to the vacuum tank

2. conventional punched calibrator, pouring the water back to the vacuum tank

- front calibrator's water spread with holes that spread the water evenly around the pipe

- anti-bubble calibrator's water distributing unit, with an additional filter with corpuscles to prevent calcification in the calibrator.

- mechanical in/out water gauges

- mechanical and digital vacuum pressure gauges

- mechanical temperature gauge

- vacuum pressure display on HMI screen, with division into colored zones, depending on work settings

Cooling tanks:

  • 2 cooling tanks

  • An additional cooling/drying tank

  • A drying chamber using air pressure

  • 316 polished stainless steel tubes

  • Anti-leakage hot water fittings

  • Easy tanks drain using one tap

line_mergeg_crop.png
bottom of page